Polipropileno Copolímero Random PP 3553-IM Snetor

Nombre del producto: PP – HOPP – MFI35 – SNETOR – 3553-IM
Categoría: Polipropileno
Información del manual del producto: www.snetor.com
Disclaimer:
The information on this document is, to our knowledge, true and accurate. Due to operating conditions and intended uses beyond our control, it is the
customer’s responsibility to establish satisfactory performance of this product for the intended application. By providing the information contained herein,
SNETOR,makes no guaranty or warranty,anddoes not assumeany liability withrespect to thecompleteness of such information.
One River Way, Ste 1125 –
Houston, TX, 77056 – USA
Email: [email protected]
Tel : +33 1 49 04 88 88
Email: [email protected]
Technical Data Sheet
www.snetor.com
POLYPROPYLENE, RANDOM
COPOLYMER
Snetor PP 3553-IM is a clarified high melt flow typically used in injection molding applications
requiring excellent clarity, rapid cycle times, good molding performance in medium to thin-wall
parts. This material meets the requirements of the U.S. Food and Drug Administration as specified
in 21 CFR 177.1520.
Applications:
Consumer products
Housewares
Thin-walled rigid packaging
NOMINAL RESIN PROPERTIES
NOMINAL VALUE
(ENGLISH)
NOMINAL VALUE
(SI)
ASTM TEST
Melt Flow Rate, (230 °C/2.16 kg)
35 g/10 min
D1238
Density
0.904 g/cm³
D792
Flexural modulus 1% secant
155,700 psi
1,074 MPa
D790A
Hardness Rockwell R
83
83
D785
Tensile strength, at 2 in/ min
@Yield
@Break
4,260 psi
2,500 psi
29.4 MPa
17.2 MPa
D638
Elongation (2 in /min)
@Yield
@Break
13.8%
>500%
13.8%
>500%
D638
Notched Izod impact strength, at
23°C
4C
1.14 ft-lb/in
0.60 ft-lb/in
5.98 kJ/m2
3.16 kJ/m2
D256
Haze @ 23C, 50-mil (1.3mm) plaque
17%
17%
D1003
PP 3553-IM