TPE Santoprene 121-70M350 Celanese

Nombre del producto: TPE – CELANESE – SANTOPRENE 121 -70M350
Categoría: Elastómero Termoplástico
Información del manual del producto: Santoprene® 121-70M350
Celanese Corporation – Thermoplastic Vulcanizate
Monday, January 22, 2024
www.ulprospector.com
UL LLC ©2024. All rights reserved.
The information presented here was acquired by UL from the producer of the product or material or original information provider. However, UL assumes no
responsibility or liability for the accuracy of the information contained on this website and strongly encourages that upon final product or material selection
information is validated with the manufacturer. This website provides links to other websites owned by third parties. The content of such third party sites is not within
our control, and we cannot and will not take responsibility for the information or content.
Page: 1 of 1
General Information
Product Description
A soft, black, UV resistant thermoplastic vulcanizate (TPV) in the thermoplastic elastomer (TPE) family. This material is designed for gap filler
applications requiring scratch resistance and good appearance. This grade of Santoprene® TPV is shear-dependent and can be processed on
conventional thermoplastics equipment for injection molding. It is polyolefin based and recyclable within the manufacturing stream.Key Features
Designed for fast, easy injection molding, especially for complex part geometries Used in sealing applications Recommended for applications
requiring superior part surface appearance Designed to be injected at lower molding temperatures or at lower injection pressures
General
Material Status
• Commercial: Active
Availability
• Africa & Middle East
• Asia Pacific
• Europe
• Latin America
• North America
Additive
• UV Stabilizer
Features
• Good Weather Resistance
• High Flow
• UV Stabilized
Uses
• Automotive Applications
Automotive Specifications
• DAIMLER DBL 5562
• VOLKSWAGEN 50123
• VOLKSWAGEN 50180
• VOLKSWAGEN TL 52622
MDX1/12
Appearance
• Black
Forms
• Pellets
Processing Method
• Injection Molding
• Multi Injection Molding
ASTM & ISO Properties 1
Physical
Nominal Value Unit
Test Method
Density / Specific Gravity
0.932
ASTM D792
Density
0.930 g/cm³
ISO 1183
Elastomers
Nominal Value Unit
Test Method
Tensile Stress – Across Flow (100% Strain)
377 psi
ASTM D412
Tensile Stress – Across Flow (100% Strain)
377 psi
ISO 37
Tensile Strength – Across Flow (Break)
899 psi
ASTM D412
Tensile Stress – Across Flow (Break)
899 psi
ISO 37
Tensile Elongation – Across Flow (Break)
480 %
ASTM D412
Tensile Elongation – Across Flow (Break)
480 %
ISO 37
Compression Set 2 (158°F, 22 hr)
40 %
ASTM D395B
Compression Set (158°F, 24 hr)
40 %
ISO 815
Hardness
Nominal Value Unit
Test Method
Shore Hardness (Shore A, 15 sec)
70
ISO 868
Notes
1 Typical properties: these are not to be construed as specifications.
2 Type 1