PE LDPE MFI7 Amco Polymers

Nombre del producto: PE – LDPE – MFI7 – AMCO – PRIMATOP 070918E
Categoría: Polietileno
Información del manual del producto: PRIMATOP® LDPE 070918E
Amco Polymers – Low Density Polyethylene
Wednesday, January 31, 2024
Amco Polymers disclaimer statement: The technical information, suggested uses, and applications presented, are made without charge and are believed to be reliable; however, Amco Polymers disclaims
responsibility for reliance on, and results of use of, this information. The data listed herein falls within the nominal range of product properties but should not be used to establish specification limits or used
alone as a basis for design. This information is not intended as a warranty of any kind. Users must make their own representative test and assume all risks of use, whether the product is used alone or in
combination with other materials. Amco Polymers assumes no obligation or liability for any advice furnished or results obtained with respect to the product, nor for use of the product in infringement of any
patent. ALL WARRANTIES, EXPRESSED OR IMPLIED, OF MERCHANTABILITY, AND FITNESS FOR A PARTICULAR PURPOSE OR USE ARE EXCLUDED AND DISCLAIMED. The foregoing
limitation of remedy and exclusion of liability is reflected in, and is part of, the consideration for the price charged for the product.
All data displayed herein has been obtained via testing of injected molded specimens of natural color. Pigmentation may affect certain properties to various degrees.
≠Shrinkage data are general guidelines and are only intended to allow comparison to other materials. They should not be used as the sole source of information for generating core and cavity mold
dimensions.
Page: 1 of 1
General Information
General
Material Status
• Commercial: Active
Availability
• North America
Features
• Good Adhesion
• Good Heat Seal
• High Flexibility
• Low Neck-In
Uses
• Flexible Packaging
• Paper Coatings
Agency Ratings
• FDA 21 CFR 177.1520(c) 3.2a
Processing Method
• Extrusion Coating
ASTM & ISO Properties 1
Physical
Nominal Value Unit
Test Method
Density
0.918 g/cm³
ASTM D1505
Melt Mass-Flow Rate (MFR) 2 (190°C/2.16 kg)
7.0 g/10 min
ASTM D1238
Mechanical
Nominal Value Unit
Test Method
Tensile Strength 3 (Yield)
10.3 MPa
ASTM D638
Tensile Elongation (Break)
550 %
ASTM D638
Flexural Modulus – 1% Secant
207 MPa
ASTM D790
Thermal
Nominal Value Unit
Test Method
Vicat Softening Temperature
83.9 °C
ASTM D1525
Notes
1 Typical properties: these are not to be construed as specifications.
2 Condition E
3 500 mm/min